Ashly NE-4250pe 4 Channel Amp + DSP
The Ashly NE-4250pe is a 4 Channel Amp + DSP.
Ashly launches the new NE-Series (NE = Network Enabled) with sixteen multi-channel amplifiers. Targeted for the performance installation and constant voltage markets, these amplifiers add a new level of power and control from the simplest to most advanced audio system applications. The models include both four and eight channel low impedance, 25V, 70V and 100V amplifiers and provide 250W of power per channel. Network Enabled (NE) amplifiers offer ease of use, full setup, control and monitoring using standard 10/100 Ethernet protocol and Protea NE Software. No special outboard control units are needed. NE Series amplifiers are offered two ways; standard input with euroblock connectors and "pe" (Protea Enabled) with euroblock input connectors and world renowned Protea DSP signal processing.
The DSP library is extensive and utilizes two SHARC 32-bit/96kHz processors. Processing blocks include Graphic, Parametric, Notch and Shelving Equalization, High-, Low- and All-Pass Filters (HPF/LPF/APF) with up to 48dB/Octave slopes, Delay, Compressor/Limiter, Gate, Ducking, Auto-leveler, Gain and Signal Generators (sinewave, white and pink noise).
A full Matrix Mixer with assignable routing allows any input to drive any or all amplifier outputs. Presets can be used to store and retrieve global parameters of an entire amplifier's control surface and DSP section.
Additionally, each amplifier also provides DC voltage control of the attenuators which makes it a snap to control volume from remote locations, preset recall, Remote Power Standby and data in and out ports for connecting accessories like the WR-5 to control user selected parameters. There are LED indicators for power, standby, protect, network communications and each channel has a four-step signal meter, bridge mono, temperature and current indicators. Four-channel Mic-pre, AES/EBU, and Cobranet input modules will be available as options.
|Signal to Noise (20 Hz-20 kHz, unweighted)|
|>98 dB||>98 dB||>98 dB||>98 dB|
|Power Consumption (Pink Noise @ 4 Ohm)|
Output Circuitry: Class D
Input Sensitivity: 6.2dBu
Frequency Response: 20 Hz - 20 kHz, +/- 1.0 dB
Damping Factor: - 8 ohm load, > 250
Input Impedance: 20 k ohms, balanced
Maximum Input Level: +21 dBu
Cooling: Temperature dependent speed-controlled fan (Front In, Side Out)
Front Panel Indicators per channel: Signal: -18, -12, -6,dB, Clip, Temp, Current, Bridge
Front Panel Indicators: overall power, standby, protect, disable, com
Attenuators: Per channel front panel
Input Connectors: each channel 3- Pin Euroblock
Output connectors: each channel Euroblock
Amplifier Protection: Output Overcurrent, DC Output, Main Supply Rail Overvoltage, Chassis Temperature, Inrush Limiting, Mains Fuse
Power Cable Connector: 15A Edison 3-Prong IEC
Dimensions 19" x 3.5" x 15.5" (88.9mm x 483mm x 394mm)
Net Weight: 21.0 lbs (9.53kg)
Shipping Weight: 26.0 lbs. (11.79kg)